I started experimenting with marine grade painting and it seems the outcomes are good enough for me. Once paint is dry – I was even able to add some decals too 🙂 Adding few finishing touches to my “Tuk Tuk Toucan” .. fuselage painting followed by side panel artwork and […]
After getting registration papers from FAA last month, we started working on finishing most of the big and little stuff for my TukTuk Toucan Cruzer … Finished clean setup and locking all the wiring properly both FWF and Inside as well Installed OAT as needed for my GRT EFIS Ordered […]
The most sensitive and fragile parts of all of the build are here now to be assembled.. Used the pointed tip of soldering iron to drill a pilot hole in lexan material followed by assembling them to the aluminum frames…
Time to balance and install the inboard and outboard flaperons on my Cruzer… The biggest job is to balance those dead weights so flaperons and balanced at center flat. Grinding the solid round bar weights is definitely a PITA…
After due planning on drilling, and running the Pitot Static lines – the routing of teflon lines is complete and it is connected to GRT EFIS as well 🙂 Wiring cleaned up All drops are secured from loose rattling.
Ok friends – I believe we met another major milestone in my Cruzer build My “Tuk Tuk Toucan” has wings now — both wings are set and angle on digital protractor shows 1.4deg on both wings
After a couple of weeks of break time with family trips – we are back to building Left wing strut done with help of my mini-helpers (two teenagers). – honestly it’s more time answering their questions than actual work but it was real fun and exciting to see youth showing […]
Ok after measuring more than 30 times for wings setup – finally drilled holes to size on wing rear channel to elephant ear attachment. – this definitely very involved to do if you don’t have another person to help you – huh! I can call it as done … all […]
Another quick and short progress update on wing mounting for my zenith cruzer A bit more work done today on wings alignment for my zenith cruzer. – the angle of incidence was set to be under 3 deg per specs – the “magic rope” method was used for wings setup […]
After successful run of my Corvair engine for a quick run (less than 3 min), I started with WIngs installation. So far was able to setup the wings in position and need additional alignment and fine tuning as recommended by fellow zenith builders. Hopeful to wrap this up in next […]
